Edit online

Editing a Transformation Scenario

Editing a transformation scenario is useful if you need to configure some of its parameters.
Note:
Since transformation scenarios that are associated with built-in frameworks are read-only, to edit one of these scenarios you will need to duplicate it and edit the duplicated scenario.
To configure an existing transformation scenario, follow these steps:

  1. Select the Configure Transformation Scenario(s) (Ctrl + Shift + C (Command + Shift + C on macOS)) action from the toolbar or the Document > Transformation menu.

    Step Result: The Configure Transformation Scenario(s) dialog box is opened.

  2. Select the particular transformation scenario and click the Edit button at the bottom of the dialog box or from the contextual menu.
    Tip:
    You could also select the scenario and the Edit button in the Transformation Scenarios view to achieve the same result.

Result: This will open an Edit scenario configuration dialog box that allows you to configure various options in several tabs, depending on the type of transformation scenario that was selected.

Figure 1. Edit Scenarios Configuration Dialog Box

Transformation Types

The Configure Transformation Scenario(s) dialog box contains a Type column that shows you the transformation type for each of the listed scenarios. Each type of transformation contains some tabs with various configuration options.

The following is a list of the transformation types and their particular tabs (click the name of each tab below to see details about all the options that are available):